Product Description
The Easy Dead Bolt is three times quicker to fit than a traditional bolt. Supplied with two strike plates to be used depending on whether you are installing a new door or using an existing door. With a 45mm spindle centre it requires only one 26mm drill bit for fitting and carries a 1 year guarantee
Works well with the Easy Click door handle range
Fitting Instructions for Urfic’s Easy Latch and Dead Bolt
- Mark required height on the door and frame
- Use a set square to mark a horizontal line on leading door edge
- Transfer height line to edge of door and frame (or as first point)
- Mark vertical centre line of the door and frame to create an intersection (cross)
- Use a 26mm flat head drill bit
- Keep drill straight and at 90 degrees-drill out hole
- Mark position of the spindle keeping drill straight/90 degrees-drill out hole
- Check the latch direction is correct (curve of latch head should face the frame)
- Insert latch into predrilled hole by pushing the round plate against the timber (check flush with door edge)
How To Fit A Strike Plate (New Door)
- With a 32mm bit, drill a hole 17mm deep at point of intersection (marked X)
- Check hole depth-do not drill more than 17mm
- Secure with fixings provided
- Position strike plate over the top
- Secure the strike plate with the fixings supplied
- Check strike plate is flush with frame
How To Fit A Strike Plate (Existing Door)
- Remove existing product
- Insert plastic rectangular casing
- Adjust position/reshape woodwork
- Position fixing plate
- Secure with fixings provided